FT-950
Operating Manual
Using IF SHIFT and WIDTH Together
The IF SHIFT and Variable IF WIDTH features together form a very effective
For example, in Figure “A”, you can see how interference has appeared both on the high and low sides of the desired signal. Press the [WIDTH] button then rotate the [SELECT(WIDTH)] knob, the interference from one side can be eliminated (Figure “B”). Next, press the [SHIFT] button and rotate the [SELECT(SHIFT)] knob to
Advice: For best interference reduction, the WIDTH and SHIFT features are the primary tools you should use. After narrowing the bandwidth (WIDTH) and/or adjusting the center of the passband (SHIFT), the Contour control may also yield additional
NARROW (NAR) One-Touch IF Filter Selection
Pressing the [NAR] button provides
| Operating Mode |
|
| [NAR] Switch |
| |||
|
|
| “ON” |
|
| “OFF” |
| |
|
|
|
|
|
|
| ||
| SSB |
| 200 Hz ~ 1.8 kHz* (1.8 kHz) |
|
| 1.8 ~ 3.0 kHz* (2.4 kHz) |
| |
| CW |
| 100 ~ 500 Hz* (500 Hz) |
|
| 500 Hz ~ 2.4 kHz* (2.4 kHz) |
| |
|
|
| 100 ~ 500 Hz* (300 Hz) |
|
| 500 Hz ~ 2.4 kHz* (500 Hz) |
| |
|
|
| 9 kHz |
|
| 16 kHz |
| |
| AM |
| 6 kHz |
|
| 9 kHz |
| |
| FM (28/50 MHz Bands) |
| 9 kHz |
|
| 16 kHz |
|
*: Depends on the [WIDTH] knob (): Default Bandwidth
Advice:
When the narrow bandwidth is selected, the “NAR” icon will appear in the display. Even if the [NAR] button has been pressed so as to engage the narrow filter, you may adjust the IF bandwidth by rotating the [SELECT(WIDTH)] knob (requires
53 | Vertex Standard Co., Ltd. |