FT-950
Operating Manual
receive mode.
Advice:
The Repeater operation will be memorized independently on each VFO stack of the
The conventional repeater shift used on 29 MHz is 100 kHz, while on the 50 MHz band the shift may vary between 500 kHz and 1.7 MHz (or more). To program the proper repeater shift, use Menu items “057 F3E 28 RPT” (28 MHz) and “058 F3E 50 RPT” (50 MHz), as appropriate.
Tone Squelch Operation
You may also use “Tone Squelch” whereby your receiver will be kept silent until an incoming signal bearing a matching CTCSS tone is receiver. Your receiver’s squelch will then open in response to the reception of the required tone.
1.Rotate the Main tuning Dial to the output frequency (downlink) from the repeater.
2.Press and hold in the [AM/FM] button for two seconds to engage the CTCSS mode.
3.Rotate the Main Tuning Dial to choose “TS” from the available choices of “OFF” “TN (Tone Encoder)” “TS (Tone Squelch)” “OFF.”
4.Rotate the
5.Press and hold in the [AM/FM] button for two seconds. A “D” notation will indicate on the “10 Hz” frequency digit in the display that the Tone Decoder is engaged (a
“T” notation will indicate on the “10 Hz” frequency digit while transmitting). Advice: The Tone Squelch operation will be memorized independently on each VFO stack of the
Memory Operation
Convenient Memory functions
The
95 | Vertex Standard Co., Ltd. |
