GE GLD8000 Series, CDW9000 Series Flashing display lights, Recommended dishwasher products, Clean

ge.com

5Start (continued)

PDW9000 Series

After selecting the cycle and desired enhancements, touch the START/RESET pad to ready the dishwasher to begin the cycle. Close the door to start the cycle or begin the DELAY START countdown. When the cycle starts, the water fill begins and approximately 60 seconds later the wash action begins.

The dishwasher will always display your last selection and enhancements. If you don’t want to change the settings, simply touch the START/RESET pad to ready the dishwasher and close the door to begin the cycle.

Also, if a power failure occurs NORMAL and HEATED DRY will automatically be programmed. Make any new selections and touch the START/RESET pad to begin the new cycle.

When the door is opened, the indicator lights will turn off if the START/RESET pad is not selected within 5 minutes. To activate the display, open and close the door or touch any pad.

6Clean

PDW8000 Series and GLD8000 Series

The CLEAN light is illuminated when the selected cycle and enhancements are complete. The light will stay ON until a pad is pressed or the door is opened and then closed.

PDW9000 Series and CDW9000 Series

The CLEAN light is illuminated and a double beep will sound when the selected cycle and enhancements are complete. You may remove the dishes at any time. The high-efficiency fan will run quietly for 30 minutes to 4 hours (depending on selected cycle) after the CLEAN light is illuminated to continue drying the dishes. The fan can be turned off by opening the door and pressing any keypad.

ALL MODELS: To turn off the audible end-of-cycle signal (or re-activate it if it was previously turned off), press the HEATED DRY pad 5 times within 3 seconds. A triple beep will sound to indicate the end-of-cycle beep option has been toggled.

Flashing display lights.

Status Indicator Lights	What It Means
START/RESET	Cycle has been interrupted by pressing the START/RESET pad, or there
	has been a power failure. Light will stop flashing after the dishwasher
	automatically drains out the water. The dishwasher will restart if the
	interruption was the result of a power failure.

Recommended dishwasher products.

Safety Instructions

Operating Instructions

Troubleshooting Tips

GE recommends the following products for use in its dishwashers:

■For your manual detergent dispenser, Cascade® and Electrasol® powder, liquid or gel automatic dishwasher detergents are approved.

■For your SmartDispenseTM Detergent Dispenser, use only the recommended detergents listed on page 10 of this manual.

■Jet Dry® or Cascade Crystal Clear® rinse agents to remove spots and prevent new film buildup on your dishes, glasses, flatware, cookware and plastic. Using rinse agent also improves dry performance.

■Cascade® Plastic BoosterTM to remove red staining inside your dishwasher that can come from some tomato-based foods.

■Cerama Bryte® Stainless Steel Appliance Cleaner to clean the exterior stainless steel panel of GE and ProfileTM dishwashers (for stainless steel exterior models only).

7

Consumer Support