General Product Care

Simply wipe the base station with a damp cloth or an antistatic wipe. Never use a dry cloth as this can cause static discharge.

Troubleshooting Guide

When you forget base PIN, following the procedure to Reset the units.

ALL MEMORY AND SETTING WILL BE LOST.

Refer to handset – Call Log Operation procedure, select DELETE ALL to delete all Call Log Memories in handset. Disconnect the line cord and AC power supply.

Hold “PAGE” button and plug in the AC power supply.

When a Beep tone heard and in-use LED turns On, release “PAGE” button. Press “PAGE” button three times again.

The In-Use LED will turn Off.

The unit will return to its default setting a PIN code (0000). Unplug AC power of base station and plug in again, handset LCD will display “ ---- ”.

Following “Registering Additional Handsets” to register all handsets again.

PROBLEMS

CAUSES

SOLUTIONS

Registration not

The battery is not

Charge the battery for

work.

sufficiently charged.

14 hours (see Battery

 

 

Charging).

 

Handset and base

Unplug and then plug

 

station were not

in the power adaptor.

 

prepare for registration.

 

No display.

The battery has not

Charge the battery or

 

been charged.

replace them (see

 

 

Battery Charging)

No reactions to

The keypad is locked.

Press * key longer

keystroke.

 

than 2 seconds.

No radio

The handset is outside

Move closer to the

connection to the

the base station range.

base station.

base station:

The handset is not

Register the handset

blinking!

registered.

(see Registering

 

 

Handset).

 

The base station does

Unplug and then plug

 

not work.

the power adaptor to

 

 

the power outlet

 

 

(220-230V AC / 50

 

 

Hz) and the other end

 

 

into the power jack

 

 

on base bottom.

Environment

Used equipment and used handset batteries must be disposed of in compliance with current environmental protection regulations. You should return them to your reseller or dispose of them at an approved recycling centre.

Do not attempt to open the batteries, as they contain chemical substance. In the event of leakage, avoid contact with the skin, eyes and mouth. In the event of contact, rinse the affected part for several minutes in running water. Clean the product with absorbent paper or a dry cloth and contact your reseller for replacement batteries.

Model: FS21828 00006822 (Rev. 1 E) 05-34

Printed in China

14

Page 14
Image 14
GE FS21828 manual General Product Care, Troubleshooting Guide, Environment