Millenium™ RO System by GE Osmonics
1.8Monitors and Controls
Inlet Water Valve Switch:
The Inlet Water Valve Switch is mounted on the control panel. The switch is used to energize a solenoid, pressurizing the system with feed water.
RO Pump Power Switch:
The RO Pump Power Switch is mounted on the control panel. The switch is used to energize the RO pump/motor. The inlet water switch must be ON for the pump/motor to operate.
Disinfect Switch:
The Disinfect Switch is mounted on the front panel. This switch is used to introduce disinfectant or cleaning agents into the RO through the disinfect port.
Pressure Adjust Regulator:
The Pressure Adjust Regulator inside the RO is used to set the maximum product pressure needed to supply a dialysis machine. Adjusting this regulator will also result in small adjustments in the pump pressure.
Product Pressure Gauge:
The Product Pressure Gauge reads the product pressure from 0 to 100 PSI. Product pressure will read zero when the product line is not connected to a dialysis unit and the product hose is connected to the product fitting and the valve is open.
Pump Pressure Gauge:
The Pump Pressure Gauge reads the pump pressure from 0 to 300 PSI. It is used for monitoring during operation and when adjusting the pump pressure, and is located on the front of the RO.
Operate/Flush Valve:
The Operate/Flush Valve is a
Disinfect Port:
The Disinfect Port is a
Feed Port:
The Feed Port is a
14693e – 31 Mar 03 | 1 - 9 | General Information |