GE GNSH45E, GXSH39E Connect to Electrical Power, Programming the Control, SET Present Time of DAY

Installation Instructions

10 CONNECT TO ELECTRICAL POWER

To gain access to the transformer/power cord assembly, remove the salt hole cover from the softener. Unclip the tabs on the rear of the top cover and rotate the cover upward to remove. DO NOT PULL OR DISCONNECT WIRING.

•The softener works on 24 volt-60Hz electric power. The included transformer changes standard 120-volt AC house power to 24 volts.

Plug the transformer into a 120-volt outlet only. Be sure the outlet is always live so it can not be switched off by mistake.

•Replace the top cover.

•Replace the salt hole cover.

PROGRAMMING THE CONTROL

PROGRAMMING THE CONTROL

CONTROL SETTINGS REQUIRED upon installation and after an extended power outage.

NOTES:

•WHEN THE TRANSFORMER IS PLUGGED INTO THE ELECTRICAL OUTLET, 12:00 PM (flashing), and an arrow is displayed next to PRESENT TIME on the faceplate decal. The blue indicator light will also flash. Program the control as instructed below.

If - - - is flashing, use the UP button

to set the correct F or P code as follows: P39 for

GXSH39E or P45 for GNSH45E. If you pass by the correct code number, use the DOWN button. Then press the MODE button to accept the correct model.

•A “beep” sounds while pressing buttons for control programming. One beep signals a change in the control display. Repeated beeps mean the control will not accept a change from the button you have pressed, and you should select another button.

•To program the control, you will use the UP , DOWN and MODE buttons.

•Use the MODE button to scroll arrow to desired control function.

SET PRESENT TIME OF DAY

1. Press the MODE button SALT
until arrow points to	LEVEL	PM
PRESENT TIME.

2.Press UP or DOWN

button to set. The UP button advances the time; the DOWN button moves the time in reverse.

. If the present time is between noon and midnight, be sure PM shows in the display. If the present time is between midnight and noon, be sure AM shows in the display.

NOTE: Each press of an UP or DOWN button changes the time by one minute. Holding the button changes the time at a rapid rate.

3.When the present time is correct, press MODE to accept.

SET WATER HARDNESS NUMBER

1. Press the MODE button SALT

LEVEL

until arrow points to

HARDNESS.

2.Press UP or DOWN

button to set your water hardness number in the display. DOWN decreases the hardness value. UP increases the hardness value.

NOTE: Each press of a button changes the display by 1, between 1 and 25. Above 25, the display changes 5 at a time (25, 30, 35, etc.). Holding a button in changes the numbers at a rapid rate.

10