GE GNSH45E, GXSH39E Service Electronic Demand Time Features and Service, Err

About the water softener system.

Service: Electronic Demand Time Features and Service

ERROR CODE
DISPLAYED	ERR 01	ERR 02	ERR 03	ERR 04	ERR 05
POSSIBLE DEFECT	• Motor	•Position	•Motor	•Position	•Control
	inoperative	switch	inoperative	switch or
			or wiring	wiring
			harness	harness
	• Wiring	•Control	•Control	•Control
	harness or
	connection
	to switch
	• Position
	switch
	• Control

To remove an error code: 1. Unplug transformer.

2.Correct defect.

3.Plug transformer in.

4.Wait for at least 6 minutes. The error code will return if the reason for the error code was not corrected.

Service: Timer/Softener, Service Checkout Procedure

If you are not getting soft water, and an error code is not displayed, use the procedures below to find the problem. First make the following visual checks.

VISUAL CHECKS:

1.Is there electrical power to the outlet the water softening system transformer is plugged into?

2.Is there sufficient salt in the storage tank?

3.Is the softener bypass valve directing water for soft water service?

4.Is the valve drain hose open to the drain, not more than 8′ above the softener, and unobstructed? If hose is above 8′, see page 8, step 5.

If you do not find a problem with the visual checks, continue below.

NO SOFT

WATER

CONTROL SHOWS WRONG TIME AND DAY, AND/OR IS FLASHING.

Electrical power was off. Reset the correct time of day.

Investigate reason for power loss.

		Check electrical
		power to control
	CONTROL	(outlet,
	DISPLAY	transformer,
	BLANK.	power cable, all
		connections).
CONTROL DISPLAY
SHOWS CORRECT TIME			Do manual
AND DAY AND IS			diagnostics.
STEADY.

NO POWER

POWER OK

REPAIR AS NEEDED

CONTROL DEFECTIVE

Do manual diagnostics to verify proper function.

18