Brother PT-2030, PT2030AD appendix Error Messages, Message Cause/Remedy

TROUBLESHOOTING

Error Messages

When an error message appears on the display, follow the directions provided below.

Message

Cause/Remedy

Battery Weak! *		The installed batteries are getting weak.
Check		The installed batteries are about to run out of power. Replace
Battery!		with new batteries or connect the AC adapter before continuing.
Wrong Type		An incompatible AC adapter is connected. After the power is
Of Adapter		turned off automatically, use the AC adapter designed
Connected!		exclusively for your P-touch labeler.
Cutter Error!	*	The tape cutter is closed when you try to print or feed tape. Turn
		the P-touch labeler off and then on again before continuing.
		When tape is tangled in the cutter, remove the tape.
No Text! *		There is no text, symbols or bar code data entered when you try
		to print or preview a label. Enter data before continuing.
Insert Tape		There is no tape cassette installed when you try to print or
Cassette! *		preview a label, or feed tape. Install a tape cassette before
		continuing.
Line Limit!		There are already five lines of text when you press the
Max 5 Lines *		Enter key. Limit the number of lines to five.
Tape Width		There are more than three lines of text when you press the Print
Limit!		or Preview key while using 0.47" (12 mm) tape. Limit the number
Max 3 Lines *		of lines to three, or replace with a larger width tape cassette.
Tape Width		There are more than two lines of text when you press the Print
Limit!		or Preview key while using 0.35" or 0.23" (9 mm or 6 mm) tape.
Max 2 Lines *		Limit the number of lines to two, or replace with a larger width
		tape cassette.
Tape Width		There is more than one line of text when you press the Print or
Limit!		Preview key while using 0.13" (3.5mm) tape. Limit the number of
Max 1 Line *		lines to one, or replace with a larger width tape cassette.
Block Limit!		There are already five blocks of text. Limit the number of blocks
Max 5 Blocks *		to five.
Text Full! *		The maximum number of characters have already been entered.
		Edit the text and use fewer characters.
Length Limit!	*	The length of the label to be printed using the text entered is
		longer than 39.37" (1 m). Edit the text so that the length of the
		label is less than 39.37" (1 m).

*Press any key to clear the error message.

56 Error Messages