GE GNSV75RWW, GNSV70RBL owner manual Installing the Tubing, Install the Battery

Models: GNSV75RWW GNSV70RBL

1 16
Download 16 pages 55.56 Kb
Page 11
Image 11

Installation Instructions

INSTALLING THE TUBING

1.Measure 3/4from the end of each remaining piece of tubing (faucet end and inlet end) and mark with a pencil (Fig. 8). (Check for roundness, smoothness, cuts, nicks, flat spots and sharp edges. It may be necessary to recut the tubing.)

3/4 (19 mm)

Fig. 8

INCORRECT

2.Locate fittings for tubing on bottom of manifold.

INLET

OUTLET

Inlet from

Outlet

supply valve

to faucet

3.NOTE: Water flow is from left to right. Water inlet is on the left side and water outlet is on the right side. Failure to follow will result in water leaks when filter canisters are removed.

4.Push the tubing firmly into each fitting on the manifold until the line is flush with the fitting collar. (If the tubing is removed, re-cut the end, measure, mark and re-insert). Tubing must be fully inserted to avoid leaks (Fig. 9). (To remove tubing, depress and hold white collet; pull tubing out to remove.)

White Collet

(DO NOT REMOVE)

Insertion line

 

3 4"

 

Insert tubing

Engagement

3/4(3/8tubing)

Fig. 9

 

INSTALLING THE TUBING (CONT.)

5.Pull out slightly on tubing to ensure a good seal.

6.Install the other end of the tubing from the inlet side of the manifold to the feed water adapter.

NOTE: Inspect the ends of the tubing to be sure there are no imperfections and that the end of the tubing is cut square. It may be necessary to cut the tubing again.

INSTALL THE BATTERY

1.Remove the lens cover from the faucet base. Grip it from both sides and pull forward.

2.Install one CR2032 3V battery with the “+” side down into the battery tray.

3.The amber LED light will flash 5 times,

indicating a proper installation and system reset . If the amber light does not flash, check

the position of the battery and make sure it is installed correctly.

4.Slide the lens cover back into the faucet base.

5.Normally, the light is off. After 6 months of use, the amber LED light will flash every 30 seconds, indicating the time to replace the filter canister.

NOTE: The amber LED light may stop blinking

if it is allowed to blink for an extended period of time. To ensure proper operation, the battery should be replaced with every filter change.

Faucet Base

Lens Cover

Battery “+” Side Down

 

11

Page 11
Image 11
GE GNSV75RWW, GNSV70RBL Installing the Tubing, Install the Battery, Locate fittings for tubing on bottom of manifold