GE GNSV70RBL Important Installation Recommendations, Contents Included With the Product

Installation Instructions

Faucet Mount Filtration System –

GNSV70RBL and GNSV75RWW

IMPORTANT INSTALLATION

RECOMMENDATIONS

WARNING — Read entire manual. Failure to follow all guides and rules could cause personal injury or property damage.

•Check with your local public works department for plumbing codes. You must follow their guides as you install the Water Filtration system.

TOOLS AND MATERIALS REQUIRED FOR INSTALLATION

•Phillips screwdriver

•Two (2) adjustable wrenches

•Electric drill and drill bit to drill 1″ hole (type as required) if mounting hole is needed for faucet

•Tape measure

•If your main water line is a rigid pipe, you will require a compression fitting and possibly other plumbing hardware to complete the installation.

CAUTION — To avoid damaging the sink, consult a qualified plumber or installer for drilling procedures. Special drill bits may be needed for porcelain or stainless steel.

CONTENTS INCLUDED

WITH THE PRODUCT

•Water filter system assembly, including mounting screws

•Feed water adapter

•Faucet assembly with electronic base monitor and tubing

6

COLD WATER SUPPLY FITTING

A. PREFERRED INSTALLATION

(Utilizing existing kitchen sink water supply valve and flexible faucet tubing)

A typical connection using the included water supply fitting is shown in the illustration below.

1.Close the water shut-off valve that is immediately in front of the supply tube and open the faucets to drain water from the sink cold water pipe.

2.Remove the nut that connects the cold water faucet to the supply tube. Some water may spill out.

NOTES:

•Be sure to turn off the water supply and open a faucet to drain the pipe.

•Make sure the gasket is installed in the water supply fitting.

Cold Water	Gasket
Faucet Stud

Water Supply Fitting

1/4″ Tubing to Water Filter Inlet

Fig. 1

Cold

Water Pipe

Cold Water Shutoff

3.Hand-tighten the water supply fitting onto the cold water faucet. Be sure the gasket, as shown, is in place before final assembly. Finish tightening with an adjustable wrench. Be careful not to overtighten or cross-thread, as damage to the threads can occur. Make sure the 1/4″ quick connection is not against a wall that causes the supply tubing connection to bend. A quarter turn to tighten or loosen the adapter may be necessary to avoid this.

4.Reconnect faucet tubing line to the fitting.

5.Install tubing. (See Installing the Tubing section.)