Installation Instructions
COLD WATER SUPPLY FITTING (CONT.)
B. OPTIONAL HOME INSTALLATION
(Where codes permit)
Saddle Valve: Saddle valve must be able to connect with
OD tubing or larger.
NOTE: Codes in the state of Massachusetts require installation by a licensed plumber and do not permit the use of the saddle valve. For installation, use plumbing code
1.Turn off the cold water supply and install saddle valve as required by product selection. (Be sure to follow manufacturer’s installation instructions.)
DANGER — If hole is required to be drilled in pipe, to protect yourself from serious injury or fatal shock, use a
2.Open saddle valve after complete system has been installed.
C. OPTIONAL INSTALLATION
(For installation with rigid pipe between supply valve and sink faucet)
Option 1
1.Remove pipe from supply valve and sink faucet .
2.Obtain flexible pipe sized to your plumbing.
3.Install flexible pipe.
4.Go back to A. Preferred Installation section step 3.
Option 2
1.Obtain compression fittings to fit rigid pipe.
2.Obtain any other fittings required to connect compression fittings to feed water adapter.
3.Remove pipe from supply valve.
4.Cut pipe to fit length of assembled fittings and adapter.
5.Install compression fitting to pipe.
6.Go back to A. Preferred Installation section step 3.
NOTE: Above described materials are not included with the product.
INSTALL THE FAUCET
Be sure there is room underneath and above the sink to make the needed connections. Before starting, make sure there is sufficient room for the faucet base and unit . Select one of the following places to install the faucet:
A. In an existing sink spray attachment or soap dispenser hole.
B. In a hole to be drilled in the sink top.
C. In a hole to be drilled in the countertop, next to the sink.
NOTES:
•Be sure the faucet base will fit flat against the surface at the selected location so the bottom gasket between the base and surface area will seal.
•Make sure to leave enough clearance at the back of the faucet in case you need to remove it.
Installation Steps (refer to illustration below for clarification)
1.If drilling is needed, make a 1″ diameter hole.
Be sure to use the proper procedure for drilling porcelain or stainless steel. Special drill bits may be needed. Consult a qualified plumber for the proper procedure.
CAUTION:When drilling in Stainless Steel, the edges may be sharp and could puncture the tube. Be careful to not cut yourself or damage the tube.
2.Remove the faucet body and base by turning the base counterclockwise.
3.Remove the butterfly bracket from the screw. Then insert the screw into the top of the base and reattach the butterfly bracket .
4.Align the gasket to cover the hole completely. Then place the butterfly bracket on the base into the hole.
Screw
Base
Sink 
Gasket
Butterfly Bracket |
5.Tighten the screw to secure the butterfly bracket to the underside of the sink top. The base should be firmly in place and should not wobble or turn.
7
