Safety Instructions
Operating Instructions
Troubleshooting Tips
Consumer Support
Flashing display lights.
Status Lights | What It Means | What To Do | |
|
|
| |
STATUS | CLEANSENSOR Error | If the sensing light doesn’t come on during the first part of the cycle, | |
SENSING | |||
| the CLEANSENSOR is not working. Call for service. The dishwasher will | ||
WASHING |
| ||
RINSING |
| continue to work without the CLEANSENSOR. | |
DRYING |
| NOTE: This light will NOT stay on the entire cycle. | |
SANITIZED |
| ||
|
|
| |
STATUS | START/RESET pad | Allow up to 90 seconds for the dishwasher to drain and reset before selecting | |
SENSING | has been pressed | a new cycle. | |
WASHING |
|
| |
RINSING |
|
| |
DRYING |
|
| |
SANITIZED |
|
| |
|
|
| |
STATUS | Control Error | Press the START/RESET pad to turn off the beeper. Turn off power at the circuit | |
SENSING |
| breaker for 10 seconds, then restore power. If the rinsing light continues to | |
|
| ||
WASHING |
| flash, then call for service. | |
RINSING |
| ||
DRYING |
|
| |
SANITIZED |
|
| |
PLUS A |
|
| |
BEEPING |
|
| |
SOUND |
|
| |
|
|
| |
STATUS | Control Error | Press the START/RESET pad to turn off the beeper and the dishwasher will | |
SENSING |
| attempt to reset. Then restart the wash cycle. If this error continues, call | |
WASHING |
| ||
RINSING |
| for service. | |
DRYING |
|
| |
SANITIZED |
|
| |
PLUS A |
|
| |
BEEPING |
|
| |
SOUND |
|
|
Using the dishwasher.
Check the Water Temperature
The entering water must be at least 120°F and | hot water faucet nearest the dishwasher, place |
not more than 150°F for effective cleaning and to | the thermometer in a glass and let the water run |
prevent dish damage. Check the water temperature | continuously into the glass until the temperature |
with a candy or meat thermometer. Turn on the | stops rising. |
Use Jet-Dry® or Cascade Rinse Aid® Rinse Agent
Filling the Dispenser
Fill the rinse agent dispenser until it reaches the bottom of lip inside the opening. Replace cap.
To check if rinse agent is needed, press the clear center of the fill cap 2 or 3 times. If rinse agent fills the center of the cap, you have enough.
A full dispenser should last about one month.
If rinse agent spills, wipe up the excess.
6
