About the dishwasher control panel.
Safety Instructions
5Start
Close the dishwasher door and select the cycle and desired enhancements. Touch the START/RESET pad to begin the cycle. Water fill begins, and approximately 60 seconds later the wash action begins.
NOTE: The dishwasher remembers your last cycle so you don’t have to reprogram each time. When the dishwasher door is fully closed, the control panel lights will display the last settings you selected.
6Clean
The CLEAN light is illuminated when a wash cycle is complete. The light will stay ON until the door is opened and then closed and latched or when a pad is pressed with the door closed. You can turn off the CLEAN light by pressing any pad when the door is latched.
If you don’t want to change any of the settings, simply touch the START/RESET pad to begin the cycle.
If the door is closed, the indicator lights will turn
off if the START/RESET pad is not selected within two minutes. To activate the display, open and close the door or press any pad.
Also, if a power failure occurs, NORMAL and HEATED DRY will automatically be programmed. Make any new selections and touch the START/RESET pad to begin the cycle.
Troubleshooting Tips
Flashing display lights.
| Status Indicator Lights | What It Means |
| START/RESET | Cycle has been interrupted by pressing the START/RESET pad. Light will stop |
|
| flashing after the dishwasher automatically drains out the water. |
Using the dishwasher. |
|
Check the Water Temperature
The entering water should be at least 120°F and not more | the dishwasher, place the thermometer in a glass and let |
than 150°F for effective cleaning and to prevent dish | the water run continuously into the glass until the |
damage. Check the water temperature with a candy or | temperature stops rising. |
meat thermometer. Turn on the hot water faucet nearest |
|
Use Jet-Dry ® or Cascade Crystal Clear® Rinse Agent
Filling the Dispenser
The rinse agent dispenser holds 3.5 oz. of rinse agent. Under normal conditions, this will last approximately one month. Try to keep it full, but do not overfill.
1 Make sure the dishwasher door is fully open.
2 Turn the dispenser cap to the left and lift it out.
3 Add rinse agent until the indicator window looks full.
4 | Clean up any spilled rinse agent with a damp cloth. | Indicator |
|
5 | Replace the dispenser cap. | window | Dispenser cap |
|
|
Support
Rinse Aid Setting
The amount of rinse agent released into the final wash can be adjusted. The factory setting is at the midpoint. If there are rings of calcium (hard water) spots on dishes, try a higher setting. If you see foam in the dishwasher, move the indicator to a lower setting.
To adjust the setting
Remove the dispenser cap; then turn the adjuster counterclockwise to increase the amount of rinse agent, clockwise to reduce the amount of rinse agent.
Rinse agent adjuster
Consumer
Dish Preparation Prior to Loading
| ■ No prerinsing of normal food soil is required. | ■ Remove leafy vegetables, meat trimmings and |
| ■ Scrape off hard soils, including bones, toothpicks, skins | excessive amounts of grease or oil. |
6 | and seeds. | ■ Remove acidic food soils that can discolor stainless |
■ Remove large quantities of any remaining food. | steel. |
|