Installation Instructions

12Remove cap from RO cartridge housing. Install RO cartridge, O-ring end first. Lubricate cover O- ring with food-grade silicone grease, if necessary. (DO NOT use petroleum jelly.) Tighten cap securely.

13If you replaced the RO cartridge, also replace the flow control and screen. (Unscrew the black 1/4″ line from the fitting. Remove flow control with clean knife edge. Remove screen with a clean toothpick.) Tighten the nut hand-tight and then tighten 1/4 turn with pliers. DO NOT

OVERTIGHTEN.

1/4″ Black tubing

Flow control

Compression nut

Screen

14Turn on water supply. Allow to fill. (May take up to four hours.) Check for leaks.

15INSTALL THE BATTERY

1.Remove the lens cover from the faucet base. Grip it from both sides and pull forward.

2.Install one CR2032 3V battery with the “+” side down into the battery tray.

3.The amber LED light will flash 5 times, indicating a proper installation and system reset.

4.Slide the lens cover back into the faucet base.

5.Normally, the light is off. After 6 months of use, the amber LED light will flash every 30 seconds, indicating the time to replace the filter canister.

NOTE: The amber LED light may stop blinking if it is allowed to blink for an extended period of time. To ensure proper operation, the battery should be replaced with every filter change.

Faucet base

Lens cover

Battery “+”side down

 

16If you only replaced the prefilter and postfilter, allow faucet to run 5 minutes to remove harmless carbon particles. If you replaced the RO cartridge, fill and empty the storage tank three times, until taste and odor from food-grade membrane preservative is gone.

17Once storage tank is full, turn on icemaker.

11