Installation Instructions
FAUCET INSTALLATION
INSTALL THE FAUCET
Be sure there is room underneath and above the sink to make the needed connections. Before starting, make sure there is sufficient room for the faucet base and unit . Select one of the following places to install the faucet:
A. In an existing sink spray attachment or soap dispenser hole.
B. In a hole to be drilled in the sink top.
C. In a hole to be drilled in the countertop, next to the sink.
NOTES:
•Be sure the faucet base will fit flat against the surface at the selected location so the bottom gasket between the base and surface area will seal.
•Make sure to leave enough clearance at the back of the faucet in case you need to remove it.
Installation Steps (refer to illustration below for clarification)
1.If drilling is needed, make a 11⁄ 2″ diameter hole.
Be sure to use the proper procedure for drilling porcelain or stainless steel. Special drill bits may be needed. Consult a qualified plumber for the proper procedure.
NOTE: When drilling in stainless steel, the edges may be sharp and could puncture the tube. Be careful to not cut yourself or damage the tube.
2.Remove the faucet body and base by turning the base counterclockwise.
3.Push the 1/4″ black tube and the 3/8″ black tube onto the correct barb fittings on the faucet base. Push the 3/8″ blue tube through the base.
3/8″ Blue tube 
Faucet base
3/8″ Barb fitting 
1/4″ Barb fitting
3/8″ Black tube 
1/4″ Black tube
4.Align the gasket to cover the hole completely. Then place the toggle screw on the base into the hole.
Faucet base
Sink 
Gasket
Toggle screw
INSTALL THE FAUCET (CONT.)
5.Tighten the toggle screw until the base is firmly in place and does not wobble or turn.
6.Push the 3/8″ blue tube up to connect
it to the fitting on the bottom of the faucet body. It should go in about 3/4″. Pull tube slightly to make sure it is secure.
Faucet body |
|
3/8″ Blue tube | Gasket |
| |
Faucet base | Sink |
| 1/4″ Black tube |
Toggle screw | 3/8″ Black tube |
| Mounting screw |
7.Push the faucet body down into the faucet base and twist clockwise until it stops into place.
NOTE: You can install the faucet so the handle is on the right or the left side.
If you want the faucet handle on the right, position the handle at the back of the faucet base before turning clockwise.
If you want the faucet handle on the left, position the handle at the front of the faucet base before turning clockwise.
Faucet | Faucet |
Faucet handle on the RIGHT | Faucet handle on the LEFT |
8.Locate the hole at the rear of the base. Insert set screw
and begin to tighten by hand. Finish tightening with the Allen wrench provided in the packet .
DO NOT OVERTIGHTEN.
7