GE GXSF27E manual Opena Nearby Soft Water Faucet, For correct water softening system

GEAppliances.com

Service: Manually Initiated Electronics Diagnostics

1.To enter diagnostics, press and hold the MODE button until (000 – –) shows in the display.

A The first 3 digits indicate water meter operation as follows:

■000 (steady) = soft water not in use…no flow through the meter.

Turbine Switches

OR

Water	Switch (B)
Meter (A)

C While in this diagnostic screen, the following information

is available and may be beneficial for various reasons.

This information is retained by the computer from the

first time electrical power is applied to the control.

■ Press and hold the UP button to display the number

of days this control has had electrical power applied.

■ Press and hold the DOWN button to display the

number of regenerations initiated by this control

—OPEN A NEARBY SOFT WATER FAUCET—

■000 to 199 (continual) = repeats display for each gallon of water passing through the meter.

Motor

Position

switch

Sensor

housing Turbine

Valve	Turbine support
	and shaft
outlet

If you don’t get a reading in the display, with faucet open, pull the sensor from the valve outlet port. Pass a small magnet back and forth in front of the sensor. You should get a reading in the display. If you get a reading, shut off water supply, unhook the in and out plumbing and check the turbine for binding.

BThe letter (P) and dash(es) indicate POSITION switch operation. The letter appearing means the switch is closed; the dash means the switch is open. Use the

RECHARGE (RECHARGE TONIGHT–RECHARGE NOW) button to manually advance the valve into each cycle and check correct switch operation.

CORRECT SWITCH
DISPLAYS	VALVE CYCLE STATUS

—— Valve in service, fill, brining, backwash or fast rinse position.

— P Valve rotating from one position to another

since the SR code number was entered.

2. Press the MODE button and hold in three

seconds until a Service Rating code appears in the display.

For correct water softening system

operation, the model code must be SR22 for model GXSF27E.

To reset the code, press the UP or DOWN button until the correct number shows.

3.Press the MODE button to return to the present time display.

If the code was changed, make ALL the timer settings.

NOTE: If the control is left in a diagnostic display or a flashing display when setting times or hardness, present time automatically returns if a button is not pressed within four minutes.

15