Read these instructions completely and carefully.
Electrical Connection
Safety Instructions
We recommend that you have the electrical hookup of your range done by a qualified electrician. Have the electrician show you where your range disconnect is located.
Call your Electric Company and ask which codes apply in your area. If there are no codes, you must follow the NATIONAL ELECTRICAL CODE, ANSI/NFPA NO. 70, latest edition. You can get a copy by writing:
National Fire Protection Association
Batterymarch Park
Quincy, MA 02269
If you fail to wire your range in accordance with governing codes, you may create a hazardous condition.
You must use a
Use #8 wire and 40 Amp fuse or circuit breaker for 240 Volt and 208 Volt systems.
Do not use aluminum wiring to connect your range to the household circuit.
Operating Instructions Care
To Make Electrical Connection
and
Remove the junction block access cover (on range back).
Effective January 1, 1996 the National Electrical Code requires that new construction (not existing) utilize a
Use only
Use a range cord rated at 40 amps with 125/250 minimum volt range and closed loop terminals. Care should be taken to center cable and strain relief within knockout hole to keep the edge from damaging the cable.
NOTE: A
Cleaning Installation
Hard Wiring
The power cord bracket also incorporates a 7/8″ diameter opening for hard wiring (armored cable, flexible conduit, romex wire, etc.).
If this type of wire is used, remove the strain relief clamp and bracket and reposition the bracket so the 7/8″ diameter hole is at the bottom to accept the hard wiring.
15
Instructions Troubleshooting Tips Customer Service
