GE JGBP35GZX Provide Adequate Gas Supply, Connect The Range To Gas, Installation Instructions

INSTALLATION INSTRUCTIONS

(continued)

1 PROVIDE ADEQUATE GAS SUPPLY

Your range is designed to operate at a pressure of

25.4 cm (10″) of water column on butane gas.

Gas Pipe and Electric Outlet Locations for Models Equipped with Sealed Burners

Make sure you are supplying your range with the

type of gas for which it is designed.

If you decide to use this range on a different type

This area allows for flush range installation with through-the-wall

76.2cm (30″)

of gas, conversion adjustments must be made by a service technician or other qualified person before attempting to operate the range on that gas.

For proper operation, the pressure of butane gas supplied to the regulator must be between 25.4 cm (10″) and 33 cm (13″) of water column. When checking for proper operation of the regulator, the inlet pressure must be at least 2.5 cm (1″) greater than the operating (manifold) pressure as given above. The pressure regulator located at the inlet of the range manifold must remain in the supply line. A flexible metal appliance connector used to

connection of pipe stub/shut-off valve and rear wall 220V outlet.

Shortest connection from hard pipe

stub location to 10.2 cm range hookup.

(4″)

(10.2 cm) (4″)

20.3 cm (8″)

6.4cm (21⁄2″)

61cm (24″)

5.1 cm (2″)

connect the range to the gas supply line should have an I.D. of 1.3 cm (1/2″) and be 1.5 m (5′) in length for ease of installation. In Canada, flexible

22.9 cm (9″)	15.9 cm
	(61⁄4″)

C

L

connectors must be single wall metal connectors no longer than 1.8 m (6′) in length.

2 CONNECT THE RANGE TO GAS

Shut off the main gas supply valve before disconnecting the old range and leave it off until

This area allows for flush range installation with through-the-floor connection of pipe stub/shut-off valve.

Gas Pipe and Electric Outlet Locations for Models Equipped with Standard Twin Burners

new hook-up has been completed. Don’t forget to relight the pilot on other gas appliances when you turn the gas back on.

Because hard piping restricts movement of the range, the use of an A.G.A.-certified flexible metal appliance connector is recommended unless local codes require a hard-piped connection. Never use an old connector when installing a new range. If the hard piping method is used, you must carefully align the pipe; the range cannot be moved after the connection is made.

To prevent gas leaks, put pipe joint compound on, or wrap pipe thread tape with Teflon* around, all male (external) pipe threads.

*Teflon: Registered trademark of DuPont

This area allows for flush range installation with

through-the-wall

connection of pipe stub/shut-off valve and rear wall 220V outlet.

22.9 cm (9″)

76.2 cm	Shortest
	connection
(30″)
	from hard pipe
	stub location to
17.8 cm	range hookup.

10.2cm (7″)

(4″)

20.3 cm (8″)

73.7 cm (29″)

61 cm (24″)

5.1 cm (2″)

6.4 cm (21⁄2″)

C

L

This area allows for flush range installation with through-the-floor connection of pipe stub/shut-off valve.

38