GE JGBP35GZX manual Before You Call For Service…, Problem, Possible Cause

Models: JGBP35GZX

1 48
Download 48 pages 3.6 Kb
Page 46
Image 46
BEFORE YOU CALL FOR SERVICE…

BEFORE YOU CALL FOR SERVICE…

(continued)

PROBLEM

POSSIBLE CAUSE

 

 

“door” APPEARS

Self-cleaning cycle has been selected but latch handle was not moved all the

IN THE DISPLAY

way to the right. Move the latch handle.

 

• Latch handle was moved to the right but a program other than self-cleaning

 

was selected. Move the latch handle to the right only when setting the

 

self-cleaning cycle.

 

 

“F—AND A NUMBER”

• If the time display flashed “F—and a number,” you have a function error code.

FLASH IN THE DISPLAY

If a function error code appears during the self-cleaning cycle, check the oven

 

door latch. The latch handle may have been moved, even if only slightly, from

 

the latched position. Make sure the latch is moved to the right as far as it will go.

 

Press the CLEAR/OFF pad. Allow the oven to cool for one hour. Put the oven

 

back into operation.

 

• Disconnect all power to the range for 5 minutes and then reconnect power.

 

If the failure code repeats, then call for service.

 

 

OVEN CONTROL SIGNALS

• This is reminding you to enter a bake temperature (see the Baking section).

AFTER ENTERING COOK

 

TIME OR STOP TIME

 

 

 

RAINBOW EFFECT IN

• This is normal. It is caused by the heat treatment applied to the oven window.

THE OVEN WINDOW

 

(on some models)

 

 

 

STRONG ODOR

• Improper air/gas ratio in oven. Adjust oven burner air shutter.

 

• An odor from the insulation around the oven liner is normal for the first few

 

times oven is used. This is temporary.

 

 

46

Page 46
Image 46
GE JGBP35GZX manual Before You Call For Service…, Problem, Possible Cause