GE JGP623ER, JGP622ER operating instructions Wok Cooking, Stove Top Grills, Air Adjustment

Wok Cooking

We recommend that you )	,	\	.	Do not use woks that	,:,,, ,,,,,,,,, w	,=
use only a flat-bottomed				have support rings. Use	2
wok. They are available				of these types of woks, @	v
at your local retail store.				with or without the ring

in place, can be dangerous. Placing the ring over the burner

grate may cause the burner to work improperly resulting in carbon monoxide levels above allowable current standards. This could be dangerous to your health. Do not try to use such woks without the ring. You could be seriously burned if the wok tipped over.

Stove Top Grills	. ::::,,,:,,:,:	, :::::::::
		, :::::::::::.

Do not use stove top grills on your sealed gas burners. If you use the stove top grill on the sealed gas burner it will cause incomplete combustion and can result in exposure to carbon monoxide levels above allowable current standards. This can be hazardous to your health.

,, :::,:::::,,

, ::::,:::::,

. :::::::

. :::::

: :.,::

Air Adjustment

An air adjustment shutter for each surface burner regulates the flow of air to the flame.

If an air adjustment is needed, remove the control knobs and control panel.

When the right amount of air flows into the burner, the flame will be steady, relatively

3/4” Inner Cone

of Flame ~

<z+’

If the flames are yellow, call for service. If the flames are yellow-tipped, you can make the adjustment yourself.

quiet and have approximately 3/4 inch sharp blue cones. This is usually the case with factory preset shutters.

(, ) 1

@

Burner

Use pliers to open the air shutter more. If they blow awav-. -- fromd –– the----burner,.close

the air shutter more. Be sure to

$ \

With too much air, the flame will be unsteady, possibly won’t burn all the way around, and will be noisy, sounding like a blowtorch.

With not enough air, you won’t see any sharp blue cones in the flame, you may see yellow tips, and soot

keep the gap in the air shutter facing straight up. Be careful not to distort the air shutter when making adjustments with the pliers.

3

NAT. ’2’ L.P.

Air Shutter

may accumulate on cookware.

Now look at the inner cone of the flame. It should be about 3/4-inch long for all surface burners. If the flame is not the rkzht lerwth. the orifice hood

m;st be;dj’usted. Use a l/2-inch \ C)rifjce l-popen-end wrench to tighten the // Valve

o;ifice hood by turnin~ in the ‘ L.P. direction to shorten and the Nat. direction to lengthen.

7