GE JTP5030 Using the clock and timer, Cleaning, Tips Consumer Support, To Set the Clock, Safety

Models: JTP2030 JTP4830 JTP2530 JTP2830 JTP5030 JKP2827 JKP2527 JKP5027 JKP4827

1 28
Download 28 pages 54.78 Kb
Page 13
Image 13
Using the clock and timer.

Using the clock and timer.

ge.com

Safety

Make sure the clock is set to the correct time of day.

To Set the Clock

The clock must be set to the correct time of day for the automatic oven timing functions to work properly. The time of day cannot be changed during a timed baking or self-cleaning cycle.

Press the CLOCK pad.

Press the HOUR and MIN + or

pads to set the time of day. Press the START pad.

Instructions

The timer is a minute timer only.

The timer does not control oven operations. The maximum setting on the timer is 9 hours and 59 minutes.

To Set the Timer

Press the KITCHEN TIMER

ON/OFF pad.

Press the HOUR and MIN + or

pads until the amount of time you want shows in the display. The maximum time you can enter in minutes is 59. Cooking times more than 59 minutes should be changed to hours and minutes. For example, enter 90 minutes as 1 hour, 30 minutes.

If you make a mistake, press KITCHEN TIMER ON/OFF and begin again.

Press the START pad.

After pressing the START pad, SET disappears; this tells you the time is counting down, although the display does not change until one minute has passed. Seconds will not be shown in the display until the last minute is counting down.

When the timer reaches :00, the control will beep 3 times followed by one beep every 6 seconds until the KITCHEN TIMER ON/OFF pad is pressed.

The 6-second tone can be canceled by following the steps in the Special features of your oven control section under Tones at the End of a Timed Cycle.

Operating Instructions Care and

To Reset the Timer

If the display is still showing the time remaining, you may change it by pressing the KITCHEN TIMER ON/OFF pad, then press the HOUR and MIN + or pads until the time you want appears in the display.

If the remaining time is not in the display (clock, delay start or cooking time are in the display), recall the remaining time by pressing the KITCHEN TIMER ON/OFF pad and then pressing the HOUR and MIN + or pads to enter the new time you want.

Cleaning

To Cancel the Timer

Press KITCHEN TIMER ON/OFF pad twice.

Troubleshooting

Control Lockout

Your control will allow you to lock out the touch pads so they cannot be activated when pressed.

NOTE: On models with touch pad controls for both ovens, this activates this feature for both ovens.

To lock/unlock the controls:

Press the HOUR and MIN – pads at the same time for 3 seconds until the display shows LOC ON.

To unlock the control, press the HOUR and MIN – pads at the same time for 3 seconds until the display shows LOC OFF.

When this feature is on and the touch pads are pressed, the control will beep and the display will show LOC ON.

The control lockout mode affects all touch pads. No touch pads will work when this feature is activated.

On models with oven knob(s), this feature is not available for the lower oven.

This adjustment will be retained in memory after a power failure.

13

Tips Consumer Support

Page 13
Image 13
GE JTP5030 Using the clock and timer, Cleaning, Tips Consumer Support, Operating Instructions Care and, To Set the Clock