Instructions
Care and cleaning of the oven.
Be sure electrical power is off and all surfaces are cool before cleaning any part of the oven.
How to Remove Protective Shipping Film and Packaging Tape
Instructions Safety
Carefully grasp a corner of the protective shipping film with your fingers and slowly peel it from the appliance surface. Do not use any sharp items to remove the film. Remove all of the film before using the appliance for the first time.
To assure no damage is done to the finish of the product, the safest way to
remove the adhesive from packaging tape on new appliances is an application of a household liquid dishwashing detergent. Apply with a soft cloth and allow to soak.
NOTE: The adhesive must be removed from all parts. It cannot be removed if it is baked on.
Operating
Control Panel
It’s a good idea to wipe the control | Do not use abrasive cleansers, strong |
panel after each use. Clean with mild | liquid cleansers, plastic scouring pads or |
soap and water or vinegar and water, | oven cleaners on the control |
rinse with clean water and polish dry | will damage the finish. A 50/50 solution |
with a soft cloth. | of vinegar and hot water works well. |
and Cleaning
Molded rib
Spring clip
Clear groove in stem
Control Knob (on some models)
The control knobs may be removed for easier cleaning.
Make sure the knobs are in the OFF positions and pull them straight off the stems for cleaning.
The knobs can be cleaned in a dishwasher or they may also be washed with soap and water. Make sure the inside of the knobs are dry before replacing.
Replace the knobs in the OFF position to ensure proper placement.
Care
Lift-Off Oven Door
Consumer Support Troubleshooting Tips
Slot
Hinge lock
Pull hinge locks down to unlock
Removal position
18
The door is very heavy. Be careful when removing and lifting the door.
Do not lift the door by the handle.To remove the door:
Fully open the door.
Pull the hinge locks down toward the door frame, to the unlocked position. A tool, such as a small
Firmly grasp both sides of the door at the top.
Close door to the door removal position, which is halfway between the broil stop position and fully closed.
Lift door up and out until the hinge arm is clear of the slot.
To replace the door:
Firmly grasp both sides of the door at the top.
With the | Bottom | Hinge arm |
door at the | edge |
|
same angle as | of slot |
|
the removal |
|
|
position, seat the |
| |
indentation of |
| Indentation |
the hinge arm |
| |
|
| |
into the bottom |
| |
edge of the hinge |
| |
slot. The notch in the hinge arm | ||
must be fully seated into the bottom | ||
of the slot. |
|
|
Fully open the door. If the door will not fully open, the indentation is not seated correctly in the bottom edge of the slot.
Push the hinge locks up against the front frame of the oven cavity, to the locked position.
Hinge arm
Hinge lock
Push hinge locks up to lock
Close the oven door.
