ENGLISH
Advanced Features
Headphone connection
Before plugging in or unplugging the headphone, reduce the volume.
Be sure your headphone have a 3.5 mm (1/8") diameter plug and impedance between 16 and 50 ohms. The recommended impedance is 32 ohms.
Plugging in the headphone disconnects the speakers automatically. Adjust the volume using the VOLUME control.
Troubleshooting chart
Many potential problems can be resolved by the owner without calling a service technician.
If something is wrong with this product, check the following before calling your authorised SHARP dealer or service centre.
General
Symptom | Possible cause |
|
|
The power is not turned | Is the unit unplugged? |
on. |
|
|
|
No sound is heard. | Is the volume level set to “0”? |
| Are the headphones connected? |
| Are the speaker wires |
| disconnected? |
|
|
The sounds from | Are the speaker wires connected |
speakers are not well | to the wrong channels? |
balanced. |
|
|
|
Noise is heard during | Move the unit away from any |
playback. | computers or mobile phones. |
|
|
When a button is pressed, | Set the unit to the power stand- |
the unit does not respond. | by mode and then turn it back on. |
| If the unit still malfunctions, |
| disconnect the unit from the |
| mains for 30 seconds, then |
| reconnect. |
|
|
Interference or noise | Is the unit placed near TV with |
occurs on the TV image. | internal aerial? Use an external |
| aerial. |
|
|
The display on the unit is | Is the display in the dimmer |
dark. | mode? |
|
|
No images are displayed. | Is the TV turned on? |
| Is the TV input switched on? |
|
|