Sharp HT-DV40H Remote control, E-20, Battery installation, Test of the remote control

Remote control

HT-DV40H HT-DV50H

ENGLISH

Battery installation

1Open the battery cover.

2Insert the supplied batteries according to the direction indicated in the battery compartment.

When inserting or removing the batteries, push them towards the battery terminals.

3Close the cover.

Precautions for battery use:

Replace all old batteries with new ones at the same time. Do not mix old and new batteries.

Remove the batteries if the unit will not be used for long periods of time. This will prevent potential damage due to battery leakage.

Caution:

Do not use rechargeable batteries (nickel-cadmium battery, etc.). Installing the batteries incorrectly may cause the unit to malfunction.

Batteries (battery packed or batteries installed) shall not be exposed to excessive heat such as sunshine, fire or the like.

Battery removal:

Open the battery cover and pull up the battery to take out.

Notes concerning use:

Replace the batteries if the operating distance is reduced or if the operation becomes erratic. Purchase 2 “AA” size batteries (UM/SUM-3, R6, HP-7 or similar).

Periodically clean the transmitter on the remote control and the sensor on the unit with a soft cloth.

Exposing the sensor on the unit to strong light may interfere with operation. Change the lighting or the direction of the unit if this occurs.

Keep the remote control away from moisture, heat, shock, and vibrations.

Test of the remote control

After installing the unit (see pages 11 - 19), check that the remote control operates correctly.

Point the remote control directly at the remote sensor on the unit.

The remote control can be used within the range shown below:

Press the ON/STAND-BY button. Does the power turn on? Now, you can use the unit.

Remote sensor

0.2m - 6 m (8" - 20’)

Preparation for Use

1 2 3

4 5 6

E-20