25
Safety Instructions Operating Instructions Care and Cleaning Troubleshooting Tips Consumer Support
Problem Possible Causes What To Do
“LOCK DOOR” flashes The self-clean cycle has been Close the oven door.
in the display selected but the door is not
closed.
LOCKED DOOR light The oven door is locked Press the CLEAR/OFF pad. Allow the oven to cool.
is on when you want because the temperature
to cook inside the oven has not
dropped below the
locking temperature.
“F— and a number You have a function Press the CLEAR/OFF pad. Allow the oven to cool for one
or letter” flash in error code. hour. Put the oven back into operation.
the display
If the function code repeats. Disconnect all power to the range for at least 30
seconds and then reconnect power. If the function
error code repeats, call for service.
Display goes blank A fuse in your home may be Replace the fuse or reset the circuit breaker.
blown or the circuit
breaker tripped.
The clock is in the See the Special features of your oven control section.
black-out mode.
Display flashes Power failure. Reset the clock.
Unable to get the Oven control pads were The BAKE and BROIL HI/LO pads must be pressed
display to show “SF” not pressed properly. at the same time and held for 3 seconds.
Power outage, Power outage or surge. Reset the clock. If the oven was in use, you must reset
clock flashes it by pressing the CLEAR/OFF pad, setting the clock
and resetting any cooking function.
“Burning” or “oily” This is normal in a new oven To speed the process, set a self-clean cycle for a
odor emitting from and will disappear in time. minimum of 3 hours. See the Using the self-cleaning
the vent oven section.
Strong odor An odor from the insulation This is temporary.
around the inside of the
oven is normal for the first
few times the oven is used.
Fan noise A cooling fan may This is normal. The cooling fan will turn off and on.
automatically turn on and
off to cool internal parts.