GE JV347* Remove Exhaust Adaptor, Remove Wiring Cover, Remove Filter, Remove Wiring Knockout

Installation Instructions

2REMOVE EXHAUST ADAPTOR

If exhausting/venting using the 31⁄4″ x 10″ rectangular duct—optional for JV338, JV347, JV348 and JV367 models only:

Remove the exhaust adaptor from the inside of the hood. Set it aside along with its mounting screws.

31⁄4″ x 10″ rectangular exhaust adaptor

and screws

5REMOVE WIRING COVER

Remove the wiring cover from inside the hood. Set the cover and its mounting screw aside.

Wiring cover

3REMOVE FILTER

Remove the shipping tape holding the metal grease filter in place. Pull down on the center of the front edge of the filter. The filter will then slip out of the retaining tabs on the back.

Metal grease filter

4REVERSE THE BAFFLE FOR

DUCTED INSTALLATIONS ONLY

(JV347, JV348 and JV367 models)

If the hood is to be recirculated, skip to the next step. Remove the baffle from the top of the hood. Re-install the baffle so the short side marked “VENTED” is visible. The long side of the baffle should be inside the hood.

“VENTED” is visible

6REMOVE WIRING KNOCKOUT

Remove either the top or the back wiring knockout as needed and install an approved strain relief clamp.

Top knockout Back knockout	Strain relief
Strain relief
	clamp
clamp

7REMOVE DUCT KNOCKOUT

If recirculating, non-vented ductless (JN327 and RN328, and optional for JV347, JV348 and JV367 models only), skip to Step 10 D and proceed.

Using a flat blade screwdriver, remove the appropriate duct knockout from the top or back of the hood.

31⁄4″ x 10″ Rectangular	7 ″ Round vertical
vertical discharge.	discharge. Remove circular
Remove top rectangular	duct knockout only.
duct knockout only.

31⁄4″ x 10″ Rectangular horizontal discharge. Remove rear rectangular duct knockout only.

10