GE JVM1730 To Install Charcoal Filter, Charcoal Filter on some models, To Remove Charcoal Filter

Models: JVM1730 JVM1740 JNM1731

1 40
Download 40 pages 3.75 Kb
Page 35
Image 35
Charcoal Filter (on some models)

Charcoal Filter (on some models)

The charcoal filter cannot be cleaned. It must be replaced. Order Part No. WB02X10943 from your GE supplier.

If the model is not vented to the outside, the air will be recirculated through a disposable charcoal filter that helps remove smoke and odors.

The charcoal filter should be replaced when it is noticeably dirty or discolored (usually after 6–12 months, depending on hood usage). See “Optional Kits,” page 9, for more information.

To Remove Charcoal Filter

Remove 2 grille screws

to remove the grille.

To remove the charcoal filter, disconnect power at the main fuse or circuit breaker panel or pull the plug.

Remove the top grille by removing the 2 screws that hold it in place. Pull the filter at the bottom until it comes free of the locking tabs. Slide the filter down and out.

To Install

Charcoal Filter

To install a new filter, remove plastic and other outer wrapping from the new filter.

1 Insert the top of the filter up and into the grooves on the inside of the top opening.

2Push the bottom of the filter in until it snaps into place behind the locking tabs.

35

Page 35
Image 35
GE JVM1730, JNM1731, JVM1740 To Install Charcoal Filter, Charcoal Filter on some models, To Remove Charcoal Filter