1.PREPARATION OF WALL CABINET AND WALL
NOTE: For easier installation make all hood and vent cutouts in the cabinet and wall before cabinet is permanently fastened in place. It is recommended that the power supply be brought into the hood from the wall below the cabinet as shown in Fig. 1. However, an optional location is shown in Fig. 2, where the power supply enters the top of the hood by passing through the wall cabinet.
A. WALL CABINET WITH RECESSED BOTTOM: Add the 2 required filler strips as shown in Fig. 3.
B. WALL CABINET WITH FLUSH BOTTOM: In some cases it may be necessary to provide clearance for the connection box cover mounting screw which extends slightly through the top of the hood. Clearance can be provided, if necessary, by carefully positioning the hood against the bottom of the cabinet and marking the screw position; clearance may then be provided by drilling a 1/4” hole in the cabinet bottom.
FLUSH OR RECESSED BOITOM CABINET
-= ‘lGURE1
1X’ dia. clearance hole in wall for recommended power supply location
Centerline matches up with centerof qnge or cooktop.
FIGURE 2
66” from bottom
for optional powerof cabinet to floor supply location
RECESSED BOITOM
These filler strips support the entire weight of the hood. Make sure they are mounted firmly and are flush with the cabinet bottom.
FIGURE 3
—
5