To Operate
(“JN” models only)
Lamp switch | Fan switch | Trim |
Lamp Switch Models: JN322, JV322 & JV332
Press for OFF and ON.
Lamp Stitch All other models.
CENTER position OFF, LE~ position NIGHT LIGHT, RIGHT position BRIGHT LIGHT.
Fan Switch
CENTER position OFF, LEFT position LOW SPEED, RIGHT position HIGH SPEED.
To Maintain
Replaceable Filter ‘6JN” models only
The efficiency of your hood depends upon a clean filter. The frequency of filter replacement depends on the type of cooking you do; however, with average, normal usage, replacement should be every 6 to 12 months.
NEVER OPERATE THE HOOD WITHOUT THE FILTER IN PLACE.
When to replace the filter: The filter has distinct color stripes of indicating material on the visible surface. It is TIME TO CHANGE when the stripes have either blended together or faded completely.
To remove: Turn the retaining clip to release the front of the filter. The filter will then slip out of the retaining tabs on the back.
To replace: Slip the back edge into the retaining tabs and lock in place with the retaining clip.
Replace with genuine GE part: filter part number WB02X8253 (JN322) or WB02X8254 (JN334, JN335, JN634, JN635).
Grease Filter “JV” models only
The efficiency of your hood depends on a clean filter. Frequency of cleaning depends on the type of cooking you do. BUT GREASE FILTER SHOULD BE CLEANED AT LEAST ONCE A MONTH. NEVER OPERATE THE HOOD WITHOUT THE FILTER IN PLACE.
To remove: Turn the retaining clip to release the edge of the filter. The filter will then slip out of the retaining tabs.
To clean: Soak and then agitate in a hot detergent solution. Light brushing may be used to remove irnbedded soil. Rinse, shake and remove moisture before replacing.
With careful handling, the filter will last for yean. If replacement becomes necessary, order the part from your dealer.
To replace: Slip the edge into the retaining tabs and lock in place with the retaining clip.
Hood
Clean grease laden surfaces of the hood frequently. Use warm detergent solution. About 1 tablespoon of ammonia may be added to the water. TAKE CARE TO NOT COME IN CONTACT WITH FILTERS AND OTHER
CAUTION: Be certain when cleaning the hood surfaces you do not touch the lamp bulb with moist hands or cloth. A warm or hot lamp bulb may break if touched with a moist surface. ALWAYS let lamp cool COMPLETELY before cleaning around it.
Motor and Fan
To Clean Motor and Fan
1.DISCONNECT THE HOOD POWER SUPPLY AT THE HOUSEHOLD DISTRIBUTION PANEL BY REMOVING THE FUSE OR SWITCHING OFF THE CIRCUIT BREAKER.
2.Remove the filter.
3.Wipe the fan blade and motor with cloth, dampened only in ammonia and warm water solution.
4.Replace the filter.
5.Reconnect the hood power supply.
U.L. Requirement
WARNING: THE ELECTRICAL WIRING AND FAN MOTOR IN THIS RANGE HOOD ARE NOT INTENDED FOR USE WITH, OR PROVIDED WITH A SOLID STA~ SPEED CONTROL. ANY SUCH ALTERATION FROM ORIGINAL FACTORY WIRING CONCEPT COULD RESULT IN DAMAGE TO THE UNIT AND/OR CREATE AN ELECTRICAL SAFETY HAZARD.
3
.