Automatic Heat Sensor
Your hood is equipped with an automatic thermostat. This thermostat is a device that will turn on or speed up the blower if it senses excessive heat above the cooking surface.
If your blower is not on, or if it is running at low speed, the thermostat will sense excessive cooking heat, override the normal blower control and turn the blower on to high speed. The blower will run until the temperature drops to normal operating level. The blower will then automatically return to its original setting.
Important Safety
CARE AND CLEANING
WARNING: ALWAYS DISCONNECT ELECTRIC POWER SUPPLY BEFORE SERVICING HOOD.
Use a mild detergent suitable for painted surfaces. | The glass visor assembly and light lens are easily | |
DO NOT USE ABRASIVE CLOTH, STEEL WOOL | removable for cleaning: | |
PADS, OR SCOURING POWDERS. Vacuum the | DO NOT clean in a dishwasher. | |
blower to clean it. Do not immerse the blower in water. | ||
Remove the light lens by opening the filter panel and | ||
| ||
| turning the 2 metal clips holding the lens in place. | |
|
|
Filter
Instructions
Operating
Slide the glass visor open.
Open the filter panel
by turning the two clips and allowing it to swing free.
Flex the filter in the middle |
|
to remove it. | Panel clip |
Wash and rinse the filter in a mild detergent solution.
Replace the filter before using the exhaust fan.
Glass visor
Grasp filter |
and bend to |
remove |
Filter panel 
Instructions
Light Bulb Replacement | Stainless Steel (on some models) |
This hood uses an F20T12 fluorescent tube and an
If the tube flickers or does not light, check the prongs on the ends of the tube to make sure they are properly seated in the tube holders.
If the tube continues to flicker or does not light, replace the tube. Slide the tube into the holders and rotate the tube so that the prongs in the holders grip the tube and hold it in place.
If the ends of the tube light but the center does not, the starter may require replacement. The starter is located behind the filter panel on the right hand side. Install the new starter by pushing the starter in and turning it clockwise.
Do not use a steel wool pad; it will scratch the surface.
To clean the stainless steel surface, use warm sudsy water or a stainless steel cleaner or polish. Always wipe the surface in the direction of the grain. Follow the cleaner instructions for cleaning the stainless steel surface.
To inquire about purchasing stainless steel appliance cleaner or polish, or to find the location of a dealer nearest you, please call our
National Parts Center1.800.626.2002
ge.com
3
