Instructions
Installation of the downdraft system. Read these instructions completely and carefully.
Instructions Operating Instructions Safety
Venting Options
Side to side adjustments:
The entire blower mounting plate can be adjusted 31⁄2″ to the left or right. This will help to align vent discharge to house ductwork.
30° Rotation
For even more flexibility, the entire blower can be rotated up to 30° toward the left or 30° toward the right.
Discharge direction
The blower assembly may be removed and turned 90° for a left or right side discharge.
■The downdraft vent is shipped with the discharge outlet pointing straight down and can be changed to the left or right side.
■A left or right 90° direction adjustment should be performed before dropping into the countertop opening.
■Flatten the shipping box to use as a pad.
■Lay the vent on its back onto the pad.
Loosen screws to adjust blower left to right
Nut location inside the blower discharge
30″ Rotation left or right
Troubleshooting Tips Installation
Customer Service
To change to a left or right discharge:
Remove 4 nuts holding the blower to the mounting plate. See illustration. One nut is just inside the blower discharge.
Remove and turn the blower to the right or left. Reinstall the 4 nuts.
To locate the ductwork holes in the cabinet floor or side walls:
Temporarily, place vent into the countertop opening.
Push the vent all the way to the back of the opening.
If you are transitioning to 6″ round, place transition piece over the discharge outlet.
–Mark the location and remove the assembly.
–Cut holes and install ductwork connections.
Order JXRB57 for installation of the blower and motor below the floor:
Order JXBC57 for installation of the blower and motor outdoors.
Discharge down
(as supplied)
Discharge right
14
Discharge left
