GE JVB37 Advance Planning-Ductwork, Advance Planning-Electrical and Gas Location, Parts Supplied

Advance Planning—Ductwork

Safety

Prepare ductwork to vent to the outdoors.

■Use the shortest and straightest duct run possible.

■–The maximum permissible length for duct run is 150 feet.

■–Refer to Duct Fittings chart to calculate equivalent length for various duct configurations.

■The downdraft blower system is designed to use 31⁄4″ x 10″ ductwork. It can be transitioned to 6″ round.

■Ductwork MUST be vented to the outside–never into a crawl space, attic or other enclosed space.

■Determine the need for a wall cap or roof cap. Order the cap in advance.

Instructions Operating

Advance Planning—Electrical and Gas Location

Plan the placement of the electrical outlet and gas (if used) carefully. Gas or electrical outlets cannot be placed on the back wall of the cabinet because it may interfere with the downdraft plenum.

■Install a standard electrical outlet within reach of the vents’ two foot long power cord.

–The vent and a gas cooktop combination can operate from the same 120 volt standard duplex outlet.

–Electric cooktops must operate from a separate 240 volt junction box.

Tools and Materials Required

■Large flat-blade screwdriver	■Carpenter’s square
■Jig saw	■Ductwork to suit the installation
Parts Supplied

Open the carton and remove parts package. Check contents to be sure all pieces are present.

4 Stabilizing brackets (all models)

Remote raise/lower assembly (for 36″ wide models only)

Wire box	Plastic strain
and screws	relief

Wire and white

connector

Instructions Installation Instructions Troubleshooting

Switch cover	Attachment
plate	bracket

Remove Packaging
■Remove the shipping materials and the carton;	Plastic ties
set carton aside. The carton can be used as a pad
when changing or adjusting vent direction.

■Remove the plastic ties on both ends at the top

of the vent.

9

Tips Customer Service