LIGHT BULB REPLACEMENT

Cooktop Light./Night Light

To replace combination cooktop/night light, first disconnect power at main fuse or circuit

breaker panel or pull plug.

\

REMOVE SCREW

Be sure bulbs to be replaced are cool before removing. Break the adhesive seal by gently unscrewing the bulbs. Replace with 40-watt

Remove screw on right side of light compartment cover and lower cover until it stops.

incandescent bulbs (WB02X4253) ‘available from your GE supplier. High intensity 40-watt bulbs

(40S 1 IN/1), which are available in supermarkets and hardware stores, may also be used for replacements. Raise light compartment cover and replace screw. Connect electrical power to microwave oven.

Oven Light

r

To replace your oven light, first disconnect Dower at main fuse or circuit b;eaker panel or pull plug. Remove the top grill by

taking out the 2 screws that hold

it in place.

Next, remove the single screw located above door near center of oven that secures light housing. Replace burned-out bulb with

a30-watt incandescent bulb (WB02X4235), available from your GE supplier.

Clean off the grease and dust on hood surfaces often. Use a solution of warm water and detergent. About 1 tablespoon of ammonia may be added to the water. Take care not to touch the filters and enamel surfaces with this solution; ammonia will darken metal.

30

Page 30
Image 30
GE JVM260BV, JVM260AV, JVM260WV, 49-8623, 164D2966P143 warranty Light Bulb Replacement, Cooktop Light./Night Light, Oven Light