Installation Instructions
ISTEP 131 CONNECT DRAIN LINE
FOLLOW ALL LOCAL CODES AND ORDINANCES.
The drain hose molded end will fit 5/8", 3/4" or 1" diameter connections on the air gap, waste tee or
disposer. Cuton the marked line as required for your installation.
Cutting Lines
4 FigureU
IMPORTANT:Do not cut corrugated portion of hose
•If a longer drain hose is required, add up to 42" of length for a total of 10ft. to the factory installed hose.
Use 5/8" or 7/8" inside diameter hose and a coupler to connectthe two hose ends. Secure the connection
with hose clamps.
Hose Clamp
Coupler
HoseClampFigureV
•Secure the drain hose to the air gap, waste tee or disposer with clamps.
NOTE: TOTAL DRAIN HOSE LENGTH MUST NOT EXCEED 10 FEETFOR PROPERDRAIN OPERATION.
DRAIN LINE INSTALLATION
•Connect drain line to air gap, waste tee or disposer using either previously determined method.
Method 1 - Air gap with waste tee or disposer
__re__re
Waste Tee Installation | Disposer Installation |
FigureW
Method 2 - High drain loop with waste tee or disposer
Fasten to underside | Fastento underside |
_..... of countertop | _ _p_ of countertop, |
Waste Tee Installation | Disposer Installation |
FigureX
IMPORTANT- |
| Rem0ve |
|
| Hopper |
When connecting drain line to | _ | Plug |
disposer, checkto be sure that drain |
|
|
plug has been removed. DISH-
WASHER WILL NOT DRAIN IF PLUG IS LEFTIN PLACE.
TIP: Avoid unnecessary service call charges. Always be sure disposer drain plug has been removed before attaching dishwasher drain hose to the disposer.
10