Installation Instructions
I STEP 21ADJUST LEVELING LEGS
•Move the dishwasher close to the installation location and lay it on its back.
/
Adjust to
Installation
Height
FigureH
•Measure installation height and dishwasher height. Extend leveling legs out from the dishwasher base, 1/4" less than installation height.
I STEP 31REMOVE TOEKICK
•Remove the 4 toekick screws. Lift off the 2 piece toekick.
I STEP 41 INSTALL POWER CORD
Skip this step if dishwasher will be direct wired.
The power cord and connections must comply with the National Electrical Code, Section 422 and/or local codes and ordinances.
•Recommended power cord length is 54" min. and 64" max.
A | B CheckThat White, Black and | ||
Remove | Green Dishwasher Wires Are Threaded | ||
Junction Box | |||
| Thru Hole in Back | ||
Cover |
| ||
|
| ||
| Ground | fWhite | |
| Black |
D Use ULListed
Wire Nuts
Figure K | C |
| |
• Connect incoming | Cord Wires Thru |
| Strain Relief |
power cord white (or ribbed) | and Tighten |
to dishwasher white, black |
|
(or smooth) to black and ground to dishwasher green wire. Use UL listed wire nuts of appropriate size.
•Replace junction box cover. Be sure wires are not pinched under the cover.
I STEP 51 INSTALL 90 ° ELBOW
• Wrap 90° elbow with thread seal tape.
• Install a 90° elbow onto the water valve.
Fill
Hose
FigureJ
90° Elbow
Water
Valve
Bracket
| Thread |
FigureL | Seal Tape |
• Do not over tighten 90° elbow, water valve bracket
could bend or water valve fitting could break.
• Position the end of the elbow to face the rear of the dishwasher.
6