Installation Preparation
PREPARE ELECTRICAL WIRING
FORPERSONAL SAFETY:Remove house
fuse or open circuit breaker before WARNINGbeginning installation. Do not use an extension cord or adapter plug with this
appliance.
Electrical Requirements
•This appliance must be supplied with 120V,60 Hz., and connected to an individual properly grounded branch circuit, protected by a 15or 20 ampere circuit breaker or time delay fuse.
•Wiring must be 2wire with ground.
•If the electrical supply does not meetthe above requirements, call a licensed electrician before proceeding.
Grounding Instructions - Cable Direct
This appliance must be connected to a grounded metal, permanentwiring system, or an equipment grounding conductor must be run with the circuit conductors and be connected to the equipment grounding terminal or lead on the appliance.
Grounding Instructions - Power Cord Models
This appliance must be grounded, In the event of a malfunction or breakdown, grounding will reduce the risk of electrical shock by providing a path of least resistance for electric current, The plug must be plugged into an appropriate outlet that is installed and grounded in accordance with local codes and ordinances.
WARNING
The improper connection of the
equipment grounding conductor can result in a risk of electric shock. Check
with a qualified electrician or service representative if you are in doubt that the appliance is properly grounded,
| I | I | \ |
_ | / ,'Ti | I | \ \ |
| I | I | \ |
|
|
| |
|
| Hole(Max.) |
|
|
|
| from |
|
|
| Cabinet |
FigureE
White
Cabinet Preparation & Wire Routing
•The wiring may enter the opening from either side, rear or the floor within the shaded area.
•Cut a
•Cable direct connections may pass through the same hole asthe drain hose and hotwater line, if convenient. If cabinetwall is metal, the hole edge must be covered with a bushing. NOTE: Power cords with plug must pass through a separate hole.
Electrical Connection to Dishwasher
Electrical connection is on the right front of dishwasher.
•For cable direct connections the cable must be routed as shown in Figure E. Cable must extend a minimum of 24"from the rear wall.
•For power cord connections, install a
4