Installation Instructions
ISTEP 161 DISHWASHER WET TEST
[] Turn on power supply (or plug power cord into outlet, if equipped).
[] Turn dial to Normal "Wash" position.
[] Close door.
[] Check to be sure that water enters the dishwasher.
If water does not enter the dishwasher, checkto be sure that water and power are turned on.
[] Check for leaks under the dishwasher. If a leak is found, turn power supply off, then tighten connec- tions. Restore power after leak is corrected.
[] Check for leaks around the door. A leak around the door could be caused by door rubbing or hitting against adjacent cabinetry. Reposition the dish- washer if necessary. See Step 9.
[] The dishwasher will drain and turn off about 5 to 7 minutes after the first fill. Check drain lines.
If leaks are found, turn power off atthe breaker and correct plumbing as necessary. Restore power after corrections are made. See Step 12.
[] Open dishwasher door and make sure most of the water has drained. If not, check that disposer plug has been removed and/or air gap is not plugged.
See Step 13. Also check drain line for kinking.
[] Run the dishwasher through another fill and drain cycle. Check for leaks and correct if required.
[] Atthe end of drain, open door and turn dial to OFFposition.
STEP 17 REPLACE TOEKICK
oio
oekick
Adjust_
or Down
FigureZ
Place
Place the inner toekick piece (with slots) against the toekick bracket. The slots should align with toekick bracket screw holes. Allow the toekick to touch the floor.
Place larger toekick over the inner piece and install 4 toekick screws.
Use additional 2 screws for installations over
Use both toekick pieces for all installation heights.
I STEP 181 LITERATURE
Be sure to leave complete literature package and installation instructions with consumer.
SPECIFICATIONSSUBJECTTOCHANGEWITHOUTNOTICEDwg.No.206C1559P106
Printedin China
