GE Numbers 2 Electronic Monitor & Diagnostic System, When your refrigerator is first plugged in

Electronic Monitor & Diagnostic System

It keeps an eye on things for you.

@Red signal light flashes to tell you when either door is open,

@G reen signal light tells you that the Door Alarm beeper has been set to sound after either door has been open 30 seconds.

@Red signal Iight tells you when freezer fmdkeeping temperature is

above normal.

@Green lighted word NORMAL indicates that no failure has been detected by the diagnostic system.

@Flashing green diagnostic codes in the display warn you

when:

53frozen foods should be checked.

mpower has been interrupted.

micemaker may not be operating properly.

IE13defrost system has failed.

mfreezer control may need to be set for a colder temperature.

What these codes mean—and what to do when they appear— is summarized on the inside of the freezer compartment door and explained more thoroughly on the following pages.

@System Check pad puts a review of the electronic diagnosii of five coded functions at your fingertip and also allows you to erase codes from display.

@Electronic control allows you to turn night light in water-and-ice dispenser on and off.

@Electronic control allows you to select ice cubes or crushed-i(x. and green signal light confirms your choice.

III

When your refrigerator

is first plugged in...

All panel lights come on for ilve seconds. a beep sounds, and lights go off except as follows:

●PF flashes in the display. Touch SYSTEM CHECK-RESET pad to erase it.

* Green word NORMAL glows.

9 Red WARM TEMPERATURE light glows if freezer compartment temperature is higher than normal. It goes off when proper foodkeeping temperature is reached.

●Door alarm beeper is activated and green light on DOOR ALARM pad glows.

●CRUSHED ice selection light

U}owso z

o Red DOOR OPEN light flashes if either door is open, goes out when doors are shut.

●Night light in water-and-ice dispenser is off.

—....- ..—	——. ..
II	I