Installation Instructions
STACKING THE WASHER AND DRYER (if desired) (cont.)
3INSTALL BRACKET TO WASHER
A.Remove washer top cap screw from the rear left . Align left bracket holes with top cap screw hole on rear left of the unit and replace screw. NOTE: Leave screws loose so dryer hole alignment will be easier.
B.Drive next screw through the bracket into the rear of the washer.
C.Repeat the above steps with the right side.
4INSTALL DRYER AND BRACKET ON DRYER
A.Lift the dryer on top of the washer. Protect the washer control panel with cardboard or other protection. Be sure to lift the dryer high enough to clear the washer control panel.
WARNING – Potential Personal Injury. More than two people are recommended to lift the dryer into position because of its weight and size. Failure to do so could result in personal injury or death.
B.Align the holes in the bracket with the holes in the back of the dryer. Using a Phillips screwdriver, attach the 2 #8 x 1/2″ tapping screws.
C.Tighten the dryer bracket screws; then tighten all stacking kit screws.
5FINALIZE THE INSTALLATION
A.Refer to the washer Installation Instructions to complete the washer installation.
B.Refer to the dryer Installation Instructions to complete the dryer installation.
C.Carefully slide or walk the stacked washer and dryer into place. Use felt pads or other sliding device to assist moving and to protect flooring.
WARNING – Potential Personal Injury. Do not push on the dryer once installed to top of the washer. Pushing on the dryer may result in pinched fingers.
Place hands here
Place
hands 
here
30
