Installation Instructions
WATER VALVE ASSEMBLY INSTALLATION INSTRUCTIONS
BEFORE YOU BEGIN
Read each step thoroughly before proceeding.
•CAUTION – Unplug the
Refrigerator. To eliminate the danger of electric shock during installation, you must unplug the refrigerator from its electrical outlet.
3ATTACH THE WATER VALVE
• Locate the female connector plug (C).
C
TOOLS YOU WILL NEED
Flat blade and Phillips | Pliers | Sharp knife |
screwdrivers |
|
|
1/4″ and 5/16″ Nutdrivers |
| Tape measure |
1 REMOVE THE COVER
At the bottom rear of the refrigerator, remove the screws holding the access cover.
Bend the cover back to access the compartment.
Be sure to save the screws as the access cover must be reinstalled later to ensure that your refrigerator will function properly.
2CUT PLASTIC WATER TUBING
•Measure 25″ (64 cm) of water tubing starting from where it is secured to the water valve. Cut off excess tubing with a sharp knife or
25″ (64 cm)
•Plug the female connector (C) onto the male terminals on the water valve (3). Either wire can go on either terminal.
C
3 |
•Fasten the water valve to the cabinet by driving the
Cabinet
8
Water valve bracket
5