Safety Instructions
Caring for the dishwasher.
Cleaning the Spray Arms and the Filters
The dishwasher will flush away all normal food soils. However, objects (fruit pits, bones, etc.) may collect in openings and should be removed occasionally to avoid clogging the drain system.
CAUTION
Personal injury hazard. Before cleaning the interior, wait at least 20 minutes after a cycle for the heating element to cool down. Failure to do so could result in burn injuries.
Operating Instructions
Retaining |
nut |
Washer
Cleaning the Spray Arms
Because hard water chemicals will clog the spray arm jets and bearings, it is necessary to clean the spray arms regularly. To remove the spray arm, twist the retaining nut 90 degrees and pull the spray arm off the shaft.
Wash the arms in soapy, warm water and use a soft brush to clean the jets. Replace them after rinsing thoroughly.
Upper rack | Retaining nut |
Main filter
Cup 
Fine filter
Cleaning the Filters
For best performance and results, the filter assembly must be cleaned regularly. The filter efficiently removes food particles from the wash water, allowing water to be recirculated during the cycle. For this reason, it is a good idea to remove the large food particles trapped in the filter frequently by rinsing the main filter and cup under running water. To remove the filter assembly, pull up on the cup handle. The entire filter assembly should be cleaned at
least once a month. To clean the main filter and fine filter, use a cleaning brush. Then, reassemble the filter parts as shown in the illustration and reinsert the entire assembly in the dishwasher, positioning it in place and pressing downward. The dishwasher must never be used without the filters. Improper replacement of the filter may reduce the performance level of the appliance and may damage dishes and utensils.
General Care Instructions
Troubleshooting Tips
Protect Against Freezing
If your dishwasher is left in an unheated place during the winter, ask a service technician to:
1Cut off electrical power to the dishwasher. Remove fuses or trip circuit breaker.
2Turn off the water supply and disconnect the water inlet line from the water valve.
3
4
Drain water from the water inlet line and water valve. (Use a pan to catch the water.)
Reconnect the water inlet line to the water valve.
Support
Two types of air gaps
Check the air gap any time your dishwasher isn’t draining well.
Does Your Dishwasher Have an Air Gap?
An air gap protects your dishwasher against water backing up into it if a drain clogs. The air gap is not a part of the dishwasher. It is not covered by your warranty. Not all plumbing codes require air gaps, so you may not have one.
The air gap is easy to clean.
1Turn off the dishwasher and lift off the chrome cover.
2Remove the plastic cap and clean with a toothpick.
Consumer
| Stainless Steel Interior— | dishwasher tub or inner door should be |
| Tub and Inner Door | scratched or dented during normal use, they will |
| The stainless steel used to make the dishwasher | not rust or corrode. These surface blemishes will |
| not affect their function or durability. | |
| tub and inner door provides the highest | |
10 |
| |
reliability available in a GEdishwasher. If the |
|
