Installation Instructions
STEP 17 DISHWASHER WET TEST
Turn on power supply (or plug power cord into outlet, if equipped).
Start the unit to check for leaks.
PDW8100-PDW8800 Series:
–Latch door
–Push RINSE ONLY pad
–Push START/RESET pad
PDW9200-PDW9800 Series:
–Push RINSE ONLY pad
–Push START/RESET pad
–Close door
Push “Rinse Only” button.
Push start/reset pad once.
Check to be sure that water enters the dishwasher. If water does not enter the dishwasher, check to be sure that water and power are turned on.
Check for leaks under the dishwasher. If a leak is found, turn power supply off, then tighten connec- tions. Restore power after leak is corrected.
Check for leaks around the door. A leak around the door could be caused by door rubbing or hitting against adjacent cabinetry. Reposition the dish- washer if necessary. See Step 12.
The dishwasher will drain and turn off about 5 minutes after it was started. Check drain lines. If leaks are found, turn power off at the breaker and correct plumbing as necessary. Restore power after corrections are made. See Step 14.
Open dishwasher door and make sure most of the water has drained. If not, check that disposer plug has been removed and/or air gap is not plugged.
See Step 14. Also check drain line for kinking.
Run the dishwasher through another “Rinse Only” cycle. Check for leaks and correct if required.
STEP 18 REPLACE TOEKICK
•Place toekick against the legs of the dishwasher.
Attachment Screws
Figure JJ
•Align the toekick with the bottom edge and make sure it is against the floor.
•Insert and tighten the two toekick attachment screws. The toekick should stay in contact with the floor.
TIP: Make sure toekick is against floor to minimize noise.
STEP 19 LITERATURE
•Be sure to leave complete literature package and installation instructions with the consumer.
SPECIFICATIONS SUBJECT TO CHANGE WITHOUT NOTICE
