Installation Instructions
STEP 13 CONNECT WATER SUPPLY | Compression Nut |
Connect water supply line to 90° elbow. | Ferrule |
|
•Slide compression nut, then ferrule over end of
water line. | Hot Water | |
• Insert water line into 90° elbow. | ||
90° Elbow Supply Line |
•Slide ferrule against elbow and secure with compres- sion nut.
IMPORTANT – Check to be sure |
|
that door spring does not rub or contact the fill hose or | Figure CC |
water supply line. Test by opening and closing the door. | |
90° Elbow | |
occurs. | Door Spring |
STEP 14 CONNECT DRAIN LINE
FOLLOW ALL LOCAL CODES AND ORDINANCES.
The drain hose molded end will fit 5/8", 3/4" or 1" diameter connections on the air gap, waste tee or disposer. Cut on the marked line as required for your installation.
Cutting Lines
1" 3/4" 5/8"
Figure DD
IMPORTANT: Do not cut corrugated portion of hose
•If a longer drain hose is required, add up to 42" of length for a total of 10 ft. to the factory installed hose. Use 5/8" or 7/8" inside diameter hose and a coupler to connect the two hose ends. Secure the connection with hose clamps.
| Hose Clamp |
| Coupler |
Hose Clamp | Figure EE |
|
•Secure the drain hose to the air gap, waste tee or disposer with clamps.
NOTE: TOTAL DRAIN HOSE LENGTH MUST NOT EXCEED 10 FEET FOR PROPER DRAIN OPERATION.
DRAIN LINE INSTALLATION
•Connect drain line to air gap, waste tee or disposer using either previously determined method.
Method 1 – Air gap with waste tee or disposer
Waste Tee Installation | Disposer Installation |
Figure FF
Method 2 –
18" |
| 18" | |
Min. |
| Min. | |
Waste Tee Installation | Disposer Installation | ||
Figure GG |
| ||
IMPORTANT – | Hopper | ||
|
| Remove | |
When connecting drain line to |
| Plug | |
disposer, check to be sure that drain | |||
| |||
plug has been removed. DISH- |
|
| |
WASHER WILL NOT DRAIN IF PLUG IS LEFT IN PLACE. |
TIP: Avoid unnecessary service call charges. Always be sure disposer drain plug has been removed before attaching dishwasher drain hose to the disposer.
10