ASSEMBLY
Assembly Section 2-21
DRAFT BEAM INSTALLATION
Install ½” O-ring breather into butt port of inboard cylinder. Install fittings in the rod
end of the cylinder according to the diagram in the Common Parts section. These
fittings should be positioned to face the butt end of the cylinder.
Next turn the clevis onto the rod of the cylinder until it is tight against the shoulder
and lock into place with locking bolt on clevis.
The inboard cylinder can now be installed into the main frame mast with the pin,
flat-washer and R-clip as shown below.
Install all fittings in the outboard cylinder and adjust to point towards the butt end
of the cylinder. Attach the hoses as specified in the parts book. Slide the cylinder
into the draft beam from the outside of the draft beam and attach cylinder to the draft
beam with clevis pin and rollpins. (ASM-C-0076)
DRAFT BEAM MOUNTING
Pull the inboard cylinder poston rod down to the extreme extended position. Slide the
draft beam under the cylinder
Using inboard cylinder as a pivot point, slide draf t beam under tractor and inst all draft
beam pin. Align hole in draft beam pin with holes in main frame boss and install cap-
screw and nylock nut. (ASM-C-0078)