ASSEMBLY
Assembly Section 2-4
CRANKSHAFT ACCESS (continued)
Find the center punched marking on the front end of the tractor(shown below), and
use it as a guide for cutting. Use a 1-3/4” ho le saw to cut a hole for the driveshaf t. Once
the hole is cut you will be able to look through the hole and see the driveshaft cover.
The driveshaft cover is held on by two bo lt s. To remove these bolt s t ake off the p ane l
covering the fan. Then you will have access to the bolts on the driveshaft cover.
The battery plate will need to st ay elevated for the crankshaf t adapter to be inst alled on the
crankshaft pulley. Tilt the crankshaft adapter and slide it into place.
Before inserting the driveshaft into the crankshaft adapter, apply Anti-Seize lubricant to
the splines of the driveshaft. Re-apply Anti-Seize once a year after that.
After the crankshaft adapter is installed & torqued, remove blocks and re-install bolts
that were removed to prop up the battery plate. (ASM-JD-0097)