Tiger Mowers JD 5065M, JD 5085M-105M manual Troubleshooting, Symptoms Cause Remedy

MAINTENANCE

MAINTENANCE

TROUBLESHOOTING

SYMPTOMS	CAUSE		REMEDY
Vibration	1. Loose Bolts		1.	Check all bolts and tighten to
				recommended torque specs.
	2.	Cutter assembly	2a.	Check for damaged blades, disc
		Unbalanced		or cuttershaft. Replace if needed.
			2b.	Check for wire, rope, etc.
				entangled in the cutter assembly
Mower will not lift	1. Hyd. Fluid Low		1.	Check and refill hydraulic fluid
	2.	Leaks in line	2.	Tighten or replace fittings and hoses
	3.	Faulty relief valve	3.	Check pressure in line. Line
				pressure should be at least 2500 PSI
	4.	Kinked or blocked	4.	Clean or replace lines
	5.	Faulty cylinder	5.	Inspect, repair or replace cylinder
Mower will not start	1. Blown fuse		1.	Check fuse between mower switch
or run				and ignition/replace
	2.	Ball valves closed	2.	Make sure valves are open
	3.	Low oil level	3.	Check hydraulic tank and fill
	4.	Line leak	4.	Check all fittings and lines,
				re-tighten or replace
	5.	Electronic	5a.	Without the tractor running, turn
		solenoid faulty		the mower switch to on. A low
				audible click is not heard if the
				solenoid is engaging the solenoid

spool. If click is not heard, leave switch in on position and with a screwdriver or other steel object, touch the small nut on the end of the solenoid. If the metallic object is not attracted to the nut, check the fuse and wiring for an open circuit. If the object is attracted but no “click” is heard, replace the solenoid.

5b. Remove the four bolts holding the small block to the main block. Lift and remove small block being careful not to damage O-rings/filter. Clean filter and re-install.

Side and Rear Flail Maintenance Section 4-6

©2011 Alamo Group Inc.