ASSEMBLY
SWITCH BOX WIRING
Route the green wires and the red wire (with the 10amp fuse) from the switchbox to the front console panel. Refer to the parts section for wiring diagram to hook up the switch box. Cover the wires from the switch box with plastic wire wrap provided. Remove the console panel under the steering wheel to access wires. Locate the neutral safety brown colored wire. Use a test light or meter to verify this wire is the neutral safety wire. There are three brown wires. Cut the brown neutral safety wire and connect the green wires from the switch box as shown in the wiring diagram.
Run the white and black wire to the solenoid valve. Route the wires through the back window with the cable control wires. Use the rubber grommet in the window to protect the wire, and route the wire out of the cab down to the 1/4” hydraulic hoses. Follow the hydraulic hoses through the wheel well to the front of the tractor.
Route the Red 14ga wire, keyed hot, from the auxillary plug to the signal post of the continuous duty solenoid. NOTE: Be certain that the power taken for the switch box is “HOT” only when the tractor ignition is “ON”.
The black wire from the switchbox should be routed to the auxilary plug.
The wires from the switch box are longer than needed and should carefully cut and spliced as required. Zip ties should be used to secure the wires to the tractor framework and hoses to eliminate vibation and rubbing.
Assembly Section
