Safety Information
BEFORE YOU BEGIN:
Read these instructions completely and carefully.
IMPORTANT – Save these instructions for local inspector’s use.
IMPORTANT – Observe all governing codes and ordinances.
Note to Installer – Be sure to leave these instructions with the Consumer.
Note to Consumer – Keep these instructions with your Owner’s Manual for future reference.
WARNING – This appliance must be properly grounded. See page 4.
AVERTISSEMENT –
Cet appareil doit être correctement mis à la terre. Consultez page 4.
If you received a damaged wine chiller, wine reserve
or beverage center, you should immediately contact your dealer or builder.
Skill Level – Installation requires basic mechanical skills. Proper installation is the responsibility of the installer. Product failure due to improper installation is not covered under the GE Appliance Warranty.
WARNINGS:
•Use this appliance only for its intended purpose.
•Immediately repair or replace electrical service cords that become frayed or damaged.
•Unplug the unit before cleaning or making repairs.
•Repairs should be made by a qualified service technician.
AVERTISSEMENT :
•Il ne faut utiliser cet appareil que pour l’usage pour lequel il a été construit.
•Il faut réparer ou remplacer immédiatement tout cordon d’alimentation électrique effiloché ou endommagé.
•Débrancher le bar ou le réfrigérateur a vin avant le nettoyage ou toute intervention.
•Les réparations doivent être faites par un technicien qualifié.
For Monogram local service in your area, call 1.800.444.1845
For Monogram service in Canada, call 1.800.561.3344
For Monogram Parts and Accessories, call 1.800.626.2002.
www.monogram.com
CONTENTS
Design Guide |
| Installation Instructions |
| Step 5, Slide Product into Cutout | 6 |
The Installation Space | 3 | Tools, Hardware | 4 | ||
Product Clearances | 3 | Grounding the Product | 4 | Step 6, Install Nameplate | 6 |
3 | Staining Wood Drawer Fronts | 4 | Step 7, Set Temperature Controls | 6 | |
|
| Installing the Custom Frame Panel ... | 4 | Custom Frame Panel Models | 6 |
|
| Step 1, Remove Packaging | 4 | ZTBSS1 Monogram |
|
|
| Step 2, Reverse Door Swing | 5 | Tubular Handle Kit | 7 |
|
| Step 3, Leveling | 6 | Template for Nameplate .. Back Cover | |
|
| Step 4, Connect Power | 6 |
|
|
2
