ZTBSS1 Monogram Tubular Handle Kit
BEFORE YOU BEGIN:
Read these instructions completely and carefully.
IMPORTANT – Save these instructions for local inspector’s use.
IMPORTANT – Observe all governing codes and ordinances.
Note to Installer – Be sure to leave these instructions with the Consumer.
Note to Consumer – Keep these instructions
with your Owner’s Manual for future reference. This kit provides a stainless steel tubular handle to coordinate with other Monogram appliances.
•The tubular handle must be installed onto the 3/4″ thick portion of the custom wood panel before the panel is secured to the door.
TOOLS AND MATERIALS REQUIRED
•Gloves to protect against sharp edges
•#2 Phillips screwdriver
•Drill and 1/4″ bit and 1/2″ spade bit
•Safety glasses
•Center punch
•Pencil
THIS KIT INCLUDES
•Tubular handle
•2 Mounting screws
•2 Handle standoffs
•2 Set screws for standoffs
•2 Nuts
•2 Washers
•Allen Wrench
INSTALL THE TUBULAR HANDLE
•Use the handle as a template to locate and mark the exact position of the screw holes. Be careful to avoid interference with custom panel mounting screws.
•Draw a pencil line, top to bottom and 7/8″ from the outside edge.
•Hold the tubular handle against the appearance side, centered on the marked line.
•Mark the screw hole locations at the center of the handle attachment posts.
•Center punch the marked hole locations. Drill 1/4″ pilot holes from the appearance side through the entire panel thickness.
•Use a 1/2″ spade bit to drill 1/4″ to 5/16″ deep into the back side of the panel. Insert washer (spacer) into the hole.
•Install screw through the handle standoff and into the pilot hole.
•Fasten nut onto the screw until the standoff is tight against the panel. The screw hole on the standoff should be pointing down toward the floor.
•Place handle attachment posts inside the standoffs.
•Use the Allen wrench to install the set screws. Tighten handle to standoffs.
7/8”
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| 30” | ||||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Custom |
| |
Framed |
| |
Panel | Tubular | |
Handle | Handle | |
| ||
Standoff |
| |
Washer | Handle | |
Nut | Attachment | |
Post | ||
| ||
| Set | |
Screw | Screw | |
|
7
