General Information About Radiant Surface Units
The radiant cooktop features heating units beneath a smooth glass surface. The surface units are shown by outlines on the glass.
Before you use the cooktop for the first time, clean it with cleaning cream. This helps protect the top and makes
NOTE: A slight odor is normal when a new cooktop is used for the first time. It is caused by the heating of new parts and insulating materials and will disappear in a short time.
When a surface unit is turned on, coils beneath the surface unit radiate heat through the glass to the cookware. The red glow of the coils will be visible through the glass. It will take the surface unit a few moments to heat up. The coil cycles on and off to maintain your selected control setting. With poor cookware, you will see frequent cycling of the unit off and on. Good, flat cookware will minimize the cycling.
Use only
Sliding aluminum cookware across the glass may leave metal marks. These metal marks will appear as small scratches. They can be removed with cleaning cream and a razor scraper.
It is safe to place hot cookware from the oven or surface on the glass surface when the surface is cool.
Avoid sliding pans on the glass cooktop. Pan edges that are even slightly rough or grit on the cooktop can cause scratches on the glass.
Even after the surface units are turned off, the glass cooktop retains enough heat to continue cooking. To avoid overcooking, remove pans from the surface units when the food is cooked. Avoid placing anything on the surface unit until it has cooled completely.
The Hot Surface Light will glow when the cooktop is hot to the touch. It is not unusual for the lights to stay lit for 30 minutes.
Cooktop
Hot Surface Indicator Light
A “HOT SURFACE” light will glow brightly when any radiant element is hot to the touch, and will remain lit after the unit is turned off until the surface is cool enough to touch.
• It comes on when the unit is hot to the touch.
• It stays on even after the unit is turned off.
• It glows brightly until the unit is safe to touch.
A “HOT SURFACE” light will glow brightly when any element is turned on.
9
